Zodiac iAquaLink Installationshandbuch Seite 15

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 16
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 14
Section 7. Troubleshooting
7.1 iAquaLink 2.0 Troubleshooting Guide
Use the troubleshooting information in the following table for suggestions.
Symptom Problem Possible Solution
The iAquaLink 2.0 is on and
the startup screen is displayed.
The override switches at the
power center operate as they
should.
The iAquaLink 2.0 is not
communicating with the power
center PCB.
Check the cabling to the iAquaLink 2.0 Web-
Connect device (all conductors).
The iAquaLink 2.0 is on and
the "Waiting for connection..."
screen is displayed, but
override switches at the power
center do not operate at all.
1. Damaged or improperly
installed CPU board.
2. Wrong CPU board.
3. Damaged power center
PCB.
1. Check alignment of the CPU board.
2. Make sure that the CPU board is revision R or
later for an AquaLink RS system. Make sure
that the CPU board is revision 6.0 or later for
PDA control system.
3. If CPU board is installed correctly, replace the
power center PCB.
Some buttons do not operate
from the iAquaLink 2.0, nor
from the power center override
switches.
Wrong CPU board installed at
the power center PCB.
Make sure that the CPU board is revision R or
later for an AquaLink RS system. Make sure that
the CPU board is revision 6.0 or later for PDA
control system.
Programs do not run at the
correct time.
The iAquaLink does not
display correct time and date.
At the iAquaLink screen, set correct time and
date.
Communication is lost. Signal Interference. The wireless iAquaLink 2.0 J-box will stop
communicating anytime interference (such
as a 2.4 GHz device) prevents a valid signal
transmission. When communication is lost the
iAquaLink screen will lock on the "waiting for
connection..." screen until a good link is again
achieved, usually within a few seconds.
Page 15
iAquaLink™
2.0
Web Connect Device for AquaLink
®
Control Systems
|
Installation Manual
ENGLISH
Seitenansicht 14
1 2 ... 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare